电热水锅炉的软化水设备怎么安装

热水锅炉软化水设备一般采用阳离子交换树脂,去除水中的Ca2+、Mg2+。我们在对热水锅炉进行软化处理时,当树脂长时间吸收钙镁离子之后,需要再生。在安装热水锅炉软化水设备时,应该注意以下细节问题,来确保设备正常运作。
Hot water boiler water softening equipment commonly used cation exchange resin to remove water, Ca2 +, Mg2 +. We softened hot water boiler, when the resin after prolonged absorption of calcium and magnesium ions in need of regeneration. When installing hot water boiler water softening equipment, you should note the following details, to ensure proper operation.

 、倥盼酃懿蛔胺,长度应不大于6米,出口需低于阀体,避免虹吸现象。
    ① outfall valve is not installed, the length should not exceed six meters, export demand is lower than the body, to avoid siphoning.

 、谙殖〕擞泄砘璞竿,还应具备一个220伏特电源。
    ② the scene in addition to the boiler water softening equipment, should also have a 220 volt power supply.

 、劢谒褂Ω么笥0点15兆帕,如低于此值,需要采取相应措施。
    ③ saliva water pressure should be greater than 0:15 MPa, as below this value, the need to take appropriate measures.

 、苡Χ怨艿捞砑邮芰χС,避免控制阀受力。
    ④ add force to deal with the pipe support, control valve to avoid stress.

 、萑人砘璞附芙尤胱岳此苁,需要安装倒流防止器。
    When hot water boiler water softening equipment ⑤ inlet water pipe access, you need to install backflow prevention device.

电热水锅炉厂家http://www.eossinc.com/

 


上一条:锅炉制造许可级别划分
下一条:电蒸汽锅炉的维护

热门产品推荐

欧美日韩一区二区综合,欧美日韩一区精品视频一区二区,欧美日韩在线,欧美日韩在线视频